 |
 |
 |
|
Nady DW-22 LT LT 24 bit Dual Digital Wireless Lapel UHF Microphone System
The Nady DW-22 Digital Wireless Microphone System brings you the superior sound quality of digital audio technology in a simple, easy-to-use and reliable package. Available in a variety of combinations (with 3 types of transmitters to choose from: Digital HT™ handheld microphone, Digital LT™ LM-14/O lapel microphone or Digital LT™ HM-3 headset), this system couldn’t be easier to set up and operate. After inserting new AA batteries in the transmitters, just connect the AC adapter as well as the audio output(s) most suited to your set up (either microphone or line level) to the receiver and turn them both on. The system is now ready to go!
This system is loaded with top professional operating features and offers the best performance and price value available in digital wireless. With 48 kHz / 24-bit digital audio conversion, low latency and clear channel operation in the UHF 900MHz band, the Nady DW-22 Digital Wireless Microphone System provides interference-free performance for any application.
- RECEIVER OVERALL SYSTEM PERFORMANCE
- Frequency Response: 20Hz – 20,000Hz +/-3dB
- Dynamic Range: 120dB (A-weighted)
- Total Harmonic Distortion: <0.1%
- Latency: 3mSec (48 kHz Sample Rate)
- RF Carrier Frequency Range: Selected frequencies between 902 and 951MHz
- Frequency Stability: +/- 20PPM, PLL controlled
- Modulation: Digital QPSK
- Operating Range: Up to 300 ft. typical (depending on site conditions);
- optimum line-of- sight
- DW-11/DW-22 RECEIVERS
- Reception : External 7.25” (18.5cm) Antenna Attached
- (DW-22 – dual antennas)
- Receiver Sensitivity : -94dBm
- Controls : Power ON/OFF, Volume Control
- Connectors : 1/4” (6.35 mm) Unbalanced phone jack (360 mV/ no load)
- XLR Balanced output (+/-12 mV/600 Ohm load)(2x for DW-22)
- LED Indicators : Power ON, RF/AF LEDs
- Unwanted Signal Rejection : 60dB image and spurious
- Power Requirements : DC 13.5V Regulated @ 400mA
- DC input : 2.1mm jack
- Weight and Dimensions : DW-11: 0.75lbs (340g)
- 8” X 6” X 1.75” (203 X 152 X 44mm)
- DW-22: 0.8lbs (363g)
- 8” X 6” X 1.75” (203 X 152 X 44mm)
- DIGITAL HT™/DIGITAL LT TRANSMITTERS
- RF Power Out : +13dBm, (50mW maximum allowed by FCC)
- RF Spurious Emissions : < –50 dB
- Audio Inputs : Digital HT™ Integral neodymium dynamic cartridge
- Digital LT™ Bodypack : 1/8” (3.5mm) locking mini-jack, for headworn or
- lavalier Mic
- CONTROLS
- HT/LT : Power On/Off, (LT) Audio Mute
- LED Indicator : Unit on (single flash), Low Battery Alert (red)
- Battery Type : 2 AA Alkaline
- Battery Life : Up to 11 Hours
- Weight and Dimensions : Digital HT™: 0.6lbs (272g) / 9.25”(L) X 2”(dia.)
- Digital LT™: 0.15lbs (68g)/ 2.5” X 4.25” X 0.5”
- (64 X 108 X 13mm)
|
|
|
 |
|
 |
|
|
|
 |
|
 |
|
Features
- A reliable digital wireless microphone system that is easy to setup and use – The superior sound quality of digital audio with digital QPSK modulation combined with the performance & reliability of the UHF frequency range.
- State-of-the art, professional 48kHz / 24-bit digital conversion for exceptional audio clarity with transparent frequency response across the entire audible range (20Hz ~ 20kHz). The truest possible sound with undetectably low latency.
- Perfect for stage performance, karaoke, public address (presentations, classes, conferences) Reliable long range operation. Digital transmission virtually eliminates interference from nearby obstacles.
- Extended operating range up to 300 feet line-of-sight
- Box contents: DW-22 dual receiver (with volume control, XLR mic outputs, ¼” line mixed output, power switch, LCD display and safety cable clip to prevent the power chord from being accidentally pulled off during operation), two wireless transmitters, AC adapter, ¼” audio cable, manual.
|
|
|
|
|
|
|